Desk accessories you can 3D print and size to your setup
Desk parts are mostly about the angle and the size of what they hold: the slope of a laptop stand, the lean of a phone stand, the thickness of a phone in its case or the diameter of a cable. Measure the thing first, then set the sliders; the proof panel shows what the model measures at the default size.
Large flat parts (stand sides, bases) print best lying flat; check that the largest part still fits your bed, the sliders here stop at 255 mm.
Laptop stand
Two side frames and a crossbar that lift a 14 inch laptop 120 mm at 12 degrees, printed flat.
Phone stand
Desk stand at 65 degrees with room for a straight USB-C plug under the phone and a rear cable slot.
Headphone stand
One-piece 250 mm desk stand with a wide curved top for over-ear headphones and a broad flat base.
Cable clip
Snap-in clip for 3 round cables side by side, with screw ears or a flat adhesive base.
Under-desk J hook
One-piece spring clamp with a J hook that clips on a desk edge, for headphones or a bag.
Designed with buildcad's AI agent, checked by the buildcad team.